BJFXX - NON-PENETRATING, FLAT, PAINT, OIL
- MSDS: BJFXX
- Manufacturer: BAKER SEALANTS AND COATINGS CO
- Product Name: NON-PENETRATING, FLAT, PAINT, OIL
- National Stock Number: 8010-00-584-3139
Product Identification
Product ID:NON-PENETRATING, FLAT, PAINT, OIL
MSDS Date:11/20/1990
FSC:8010
NIIN:00-584-3139
MSDS Number: BJFXX
Responsible Party
JERSEY CITY, NJ 07304-3306
US
Emergency Phone: 201-333-6986
Info Phone: 201-333-6986
Cage: 34094
Contractor
Telephone: 201-333-6986
Cage: 34094
Ingredients
TITANIUM DIOXIDE
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 20.0%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST; 9293
SILICA, CRYSTALLINE - QUARTZ
CAS: 14808-60-7
RTECS: VV7330000
Fraction By Weight: 17.0%
OSHA PEL SEE TABLE Z3
ACGIH TLV: 0.1 MG/M3 RDUST;9293
CALCIUM CARBONATE (MARBLE) (LIMESTONE)
CAS: 1317-65-3
RTECS: EV9580000
Fraction By Weight: 10.0%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST; 9192
MAGNESIUM SILICATE
CAS: 14807-96-6
RTECS: VV7720000
Fraction By Weight: 8.0%
STODDARD SOLVENT
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 13.0%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM; 9293
ALKYD RESIN
Fraction By Weight: 14.0%
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:CHRONIC OVEREXPOSURE MAY CAUSE DAMAGE
TO THE CENTRAL NERVOUS SYSTEM, RESPIRATORY SYSTEM, LUNGS, EYES,
SKIN, AND DIGESTIVE TRACT.
Effects of Overexposure:EYES: PROLONGED OR REPEATED CONTACT MAY CAUSE
STINGING, TEARING, & REDNESS. SKIN: OVEREXPOSURE MAY CAUSE REDNESS,
BURNING, DRYING & CRACKING OF SKIN. INHALATION/INGESTION:
OVEREXPOSURE MAY CAUSE DROWS INESS, DIZZINESS, LOSS OF COORDINATION
& FATIGUE.
Medical Cond Aggravated by Exposure:PRE-EXISTING LUNG DISORDERS (E.G.,
ASTHMA-LIKE CONDITIONS) MAY BE AGGRAVATED BY EXPOSURE TO THIS
MATERIAL.
First Aid
First Aid:EYES: FLUSH WITH WATER FOR 15 MIN. SKIN: REMOVE CONTAMINATED
CLOTHES, WASH AFFECTED AREA W/MILD SOAP & WATER. INHALATION: MOVE
TO FRESH AIR. IF BREATHING STOPPED, GIVE CPR. IF BREATHING
DIFFICULT, ADM IN OXYGEN BY QUALIFIED PERSONNEL. INGESTION:
ASPIRATION HAZ. DO NOT INDUCE VOMITING OR GIVE ANYTHING BY MOUTH.
PLACE VICTIM ON LEFT SIDE W/HEAD DOWN. GET MED ATTN IMMED FOR ANY
OF THESE CONDITIONS.
Fire Fighting
Flash Point Method:SCC
Flash Point:105F/41C
Lower Limits:0.7
Upper Limits:6.0
Extinguishing Media:EXTINGUISH WITH DRY CHEMICAL, CO2 OR FOAM.
Fire Fighting Procedures:SHOULD USE SCBA. WATER SPRAY MAY BE USED TO
MINIMIZE VAPORS & COOL CONTAINERS EXPOS TO HEAT/FLAME. AVOID
SPREADING BURNING LIQ W/WTR USED FOR COOLING PURPOSES.
Unusual Fire/Explosion Hazard:THIS MATERIAL IS COMBUSTIBLE AND MAY BE
IGNITED BY HEAT OR FLAME. THIS MATERIAL WILL BURN, BUT WILL NOT
IGNITE READILY.
Accidental Release
Spill Release Procedures:STAY UPWIND & AWAY FROM SPILL. KEEP AWAY FROM
IGNITE SOURCES. VENTILATE AREA, USE SAND OR OTHER INERT MATERIAL TO
CONTAIN SPILL. DO NOT FLUSH AREA W/WATER. PREVENT CONTAMINATION OF
SEWERS OR WATERWAYS . CONTACT FIRE AUTH & FED, STATE,
LOCALAGENCIES.
Exposure Controls
Respiratory Protection:ADVISED WHEN CONCENTRATION EXCEED THE
ESTABLISHED EXPOSURE LIMITS. DEPENDING ON AIRBORNE CONCENTRATION,
USE A RESPIRATOR OR GAS MASK WITH APPROPRIATE CARTRIDGES &
CANNISTERS (NIOSH-APPROVED, IF AVAILA BLE) OR SUPPLIED AIR
EQUIPMENT.
Ventilation:MAINTAIN AIRBORNE CONCENTRATON BELOW ESTABLISHED LIMITS.
WHERE EXPLOSIVE MIXTURES PRESENT, UTILIZE ADEQUATE SYSTEMS.
Protective Gloves:IMPERMEABLE GLOVES
Eye Protection:APPROVED EYE PROTECTION
Supplemental Safety and Health
Chemical Properties
Boiling Pt:B.P. Text:318 TO 383F
Vapor Pres:3.0 @ 68F
Vapor Density:3.9
Spec Gravity:1.45
Viscosity:82-95
Evaporation Rate & Reference:0.13
Solubility in Water:INSOLUBLE
Appearance and Odor:PAINT, PET, SPTS
Percent Volatiles by Volume:54.0
Stability
Stability Indicator/Materials to Avoid:YES
CARBON MONOXIDE WHEN BURNED.
Hazardous Decomposition Products:CARBON MONOXIDE AND/OR CARBON DIOXIDE.
Disposal
Waste Disposal Methods:DISPOSE OF PRODUCT IN ACCORDANCE WITH LOCAL,
COUNTY, STATE, AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.